Unjacketed Two-Piece Pressure Reactor without bottom outlet
Model: 6423
Order NO.: 6423
929
Specific parameters will be adjusted according to product upgrades, without notice.
The following ChemTron heavy wall borosilicate glass Pressure Reactor have been designed and tested to provide the chemist with a system to perform low to moderate positive pressure reactions, synthesis, and catalysis; or simply to run reactions under inert gas conditions. Reactor capacities range from 500mL to 5000mL, and use Screw threads to achieve a leak-tight system.
Two types of Pressure Reactor are available:
1— Two-Piece System, with a maximum pressure limit of 35psig @ 100℃
2— One-Piece System, with a maximum pressure limit of 45psig @ 100℃
The Two-Piece System consists of a flanged flask and head with a shallow O-Ring groove, O-Ring, and quickrelease clamp. Flange sizes range from 60mm to 150mm inside diameter, allowing the use of large agitators and facilitating product removal and clean-out.
The One-Piece System provides a #25 center opening, with smaller openings as side necks, and has a higher allowable operating pressure.
Both systems offer jacketed and unjacketed vessels, with or without bottom outlet valves. These jackets are heat-sealed. Complete systems and their components are listed on the following pages. Systems are available with:
> Liquid addition funnel
> Solid addition funnel
> Stirring motor, controller and flexible shaft
> Heating mantle and temperature control system
> Thermowell
> Moisture test receiver
> Temperature controller with thermocouple
> Pressure relief manifold
> System frame
Due to varying conditions, ChemTron cannot guarantee glassware against breakage caused by pressure or vacuum.
Safety is the foremost concern when operating pressurized glass Reactor. With this in mind, ChemTron offers a separate manifold, 6448 (see photo), which MUST be used in conjunction with all pressure systems listed in this catalog. It consists of a glass manifold with Screw threads, PTFE adapters, a pressure gauge, a primary adjustable pressure release valve, and a secondary fixed pressure rupture disc. In addition, approved safety shields, eye and body protection should be used to avoid personal injury.
6423 Series
Unjacketed Two-Piece Pressure Reactor without bottom outlet
Order information
CRS6423-200 | 500ml System (60mm flange) |
CRS6423-205 | 500ml System (100mm flange) |
CRS6423-210 | 1000ml System (100mm flange) |
CRS6423-215 | 2000ml System (100mm flange) |
CRS6423-220 | 3000ml System (150mm flange) |
CRS6423-225 | 5000ml System (150mm flange) |
About Contact Statement Privacy Policy
Copyright © 2024 WIGGENS CO., LTD. All rights reserved.